[WBEL-users] connect to internet

Rogue Spider rogue_spider at yahoo.com
Sun Nov 2 09:01:47 CST 2008


OK i have the driver and installed by rpm and nothing
symbolic link for modem has not modem protacals and
modem is busy when tryed to query.
so i unloaded rpm,
and i have wasted a week trying to get a pci modem to work
and your only helpfull responce was try another os
sad ;<
how can you call whitehat a os with little to no support
for its users.
it feels like you took a redhat distro rebranded it and slaped
a label on it and throw it out. your not sure how to run it
support it or anything else.

--- On Thu, 10/30/08, Mike B. <saber at omniphile.com> wrote:

> From: Mike B. <saber at omniphile.com>
> Subject: Re: [WBEL-users] connect to internet
> To: whitebox-users at beau.org
> Date: Thursday, October 30, 2008, 11:31 PM
> > At Thu, 30 Oct 2008 10:16:20 -0700 (PDT)
> Killer at yourdoor.knockknock wrote:
> > 
> >> here is the kicker
> >> did a /sbin/lspci
> >> result list was
> >> etc0: Broadcom corperation BCM440 110/100 Mbps
> PCI(rev 02)
> >> modem: Broadcom corperation BCM4212 v.90 56k modem
> (rev 02)
> 
> Check this:
> 
> http://www.linuxquestions.org/questions/slackware-14/installing-modem-broadcom-corporation-bcm4212-449422/
> 
> Someone else has the same modem:
> 
> ------
> I need help setting up my modem. I have a driver that might
> work BCMSM-3.4.19-6.i386.rpm
> 
> /sbin/lspci -vv
> 02:01.0 Modem: Broadcom Corporation BCM4212 v.90 56k modem
> (rev 02) (prog-if 00 [Generic])
> Subsystem: Dell: Unknown device 0002
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR+ FastB2B-
> Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast
> >TAbort+ <TAbort- <MAbort- >SERR- <PERR-
> Latency: 64
> Interrupt: pin A routed to IRQ 5
> Region 0: Memory at fcffa000 (32-bit, non-prefetchable)
> [size=4K]
> Region 1: I/O ports at df30 [size=16]
> Capabilities: [40] Power Management version 2
> Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=55mA
> PME(D0+,D1+,D2+,D3hot+,D3cold+)
> Status: D0 PME-Enable- DSel=0 DScale=2 PME-
> ------
> 
> -- Mike B.
> _______________________________________________
> Whitebox-users mailing list
> Whitebox-users at beau.org
> http://beau.org/mailman/listinfo/whitebox-users


      


More information about the Whitebox-users mailing list